Dixell Manual Online

Designed for "step control" of multiple compressor stages or condenser fans. Essential Programming Instructions

Press and release the key. The display will flash the desired temperature (e.g., "34°F"). Press SET again to exit. dixell manual

| Code | Description | Typical Range | Notes | | :--- | :--- | :--- | :--- | | | Minimum Setpoint Limit | 32°F (0°C) | Prevents setting too warm | | US | Maximum Setpoint Limit | 50°F (10°C) | Prevents setting too cold | | OdS | Output delay at startup | 1-5 min | Compressor protection | | rtr | Defrost interval (hours) | 4-8 hrs | Time between defrost cycles | | rtc | Defrost max duration | 20-30 min | Safety cut-off for defrost | | dit | Defrost drain time | 2-5 min | Post-defrost drip delay | | FSt | Fan setpoint (evap temp) | 36°F (2°C) | Fans stop below this temp | | CAL | Probe calibration offset | +/- 5°F | Correct for sensor drift | | P2P | Probe 2 configuration | - | Set as evaporator or auxiliary | Designed for "step control" of multiple compressor stages