| Problem | Solution | |--------|----------| | Disposal won’t loosen with hex wrench | Use more force or tap wrench with hammer; ensure you’re turning correct direction (counterclockwise from bottom). | | Snap ring stuck | Spray with penetrating oil, use two screwdrivers to pry. | | Rusted hose clamp | Cut hose with utility knife, replace clamp. | | Dishwasher drains slowly after removal | If disposal gone, run dishwasher drain hose into a high loop under sink then to a branch tailpiece. |
To verify the power is completely off. Step 1: Safety First – Disconnect Power remove insinkerator
Residual water will be trapped in the "P-trap" (the U-shaped pipe), so place a bucket underneath before you begin. Installing a Replacement Garbage Disposal | Problem | Solution | |--------|----------| | Disposal
if your InSinkErator is hardwired, locate your electrical service panel and flip the circuit breaker dedicated to the disposal to the "OFF" position. | | Dishwasher drains slowly after removal |